ProPuck Catcher Installation

You must first remove the cups from your game before installing the ProPuck Catchers. Click here for instructions to remove the cups.

To install the ProPuck Catchers:

1 - Turn the game upside down

2 - Pull the goalie rod out completely

3a - Remove the covering off the two pieces of tape located on the leading edge of the ProPuck Catcher.

3b - Tilt the door side of the ProPuck Catchers down and slide into the slots of the game supports.

4 - Lift gently on the back of the ProPuck Catchers and pull back to position against the back of the game.

5 - Gently press down the front of the ProPuck Catchers until it seats against the game supports.

This is the correct technique for removing a puck from the ProPuck Catchers. Use the
one finger "fish hook" technique to remove the puck.

** End of Instructions **